1. Turn the FTDX1200's [POWER] switch "Off", and turn off the external DC power supply.
2. Disconnect all the cables from the
FTDX1200.
3. Referring to Figur 1, remove the 18 screws attaching the bottom case, then remove the bottom case.
4. Refer to Figur 2 for the mounting location for the DVS-6.
5. Push the DVS-6 (component side up), onto the pins corresponding to its assigned mounting loaction on the transceiver. Gently press the board down until it is firmly seated on the connectors.
6. Replace the botton case and 18 screws.
7. Connect the antenna and DC power supply to the
FTDX1200.
